lkjiol Posted February 13, 2022 Report Share Posted February 13, 2022 請索取 連線圖 上的PIN 28 CAN H & PIN 29 CAN L 要什麼接用的? Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 13, 2022 Report Share Posted February 13, 2022 I hope google translation has given me a good translation of your question. These pins are for CAN bus - CAN bus is a communication network so the ecu can send or receive data from other electronic devices. You dont need to connect anything to these pins if you dont have and CAN devices. CAN is commonly used for example to connect a motorsport dashboard, or Lambda sensor controller. Quote Link to comment Share on other sites More sharing options...
lkjiol Posted February 14, 2022 Author Report Share Posted February 14, 2022 18 小時前,Adamw 說: 我用谷歌翻譯給我一個很好的翻譯希望你的問題。 如果你的郵件 - CAN 沒有接收到來自其他電子設備的通信網絡,則可以發送這些數據,然後將任何東西連接到這些端口。於連接賽車儀表板或 Lambda 傳感器控制器。 感謝你的回覆 和我想的一樣 Quote Link to comment Share on other sites More sharing options...
lkjiol Posted March 27, 2022 Author Report Share Posted March 27, 2022 can you help me see The issue is won't start Log 2022-03-24 4;45;37 pm.llg Quote Link to comment Share on other sites More sharing options...
Ash Bell Posted March 27, 2022 Report Share Posted March 27, 2022 can you upload a copy of the tune so we can have a look, also what engine is this running? Quote Link to comment Share on other sites More sharing options...
lkjiol Posted March 27, 2022 Author Report Share Posted March 27, 2022 Installed on 2JZ-GTE vvti 2jz.pclr Quote Link to comment Share on other sites More sharing options...
essb00 Posted March 27, 2022 Report Share Posted March 27, 2022 That's a G4+... your ignition table is not yet set (all are on 0°) Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 27, 2022 Report Share Posted March 27, 2022 Your trigger offset also looks incorrect. 2JZ VVT trigger offset is usually around 205° Quote Link to comment Share on other sites More sharing options...
lkjiol Posted March 28, 2022 Author Report Share Posted March 28, 2022 thank you all I thickened the oil supply Turn the ignition to 205 degrees has been activated 2jz1.pclr Log 2022-03-28 4;08;46 pm.llg Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.