Jump to content

Switching multi-boost table by DI and CAN DI


Recommended Posts

I have been using a rotary switch of non-short to switch the multi-boost table. DI7on, DI8 off for table2. DI8on, DI7off for table3.
Now I want to set up a scramble boost that be controled by CAN so I want to use DI7 for table 2 and CAN DI5 for table 3.
In this case, move from table2 to table3. Both DI7 and CAN DI5 will be active at the same time, but table 3 seems to have priority.
Is this behavior correct? Also, does it interfere with the circuit if they are active at the same time like this?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...