nterry Posted June 17, 2013 Report Share Posted June 17, 2013 I installed one of AEM's fuel pressure sensor's and configured it via kpa . 05 V TO 4.95 V . The sensor reads good and fine but the differential pressure is not being Calculated. Any pointers? Quote Link to comment Share on other sites More sharing options...
Simon Posted June 17, 2013 Report Share Posted June 17, 2013 Could you post your map here or email it through to [email protected] Quote Link to comment Share on other sites More sharing options...
nterry Posted June 18, 2013 Author Report Share Posted June 18, 2013 sent Quote Link to comment Share on other sites More sharing options...
Simon Posted June 18, 2013 Report Share Posted June 18, 2013 Hi Thanks got you map and have run it up on the bench. It is not responding as you say and I can't fault your set up. I have passed on to engineering to take a look. Quote Link to comment Share on other sites More sharing options...
Simon Posted June 18, 2013 Report Share Posted June 18, 2013 Have identified an issue. A workaround is to move your input for the fuel pressure to AN volt 2. And then move your TPS signal to AN volt 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.