spawn_CA18 Posted July 10, 2013 Report Share Posted July 10, 2013 Hello , I have checked all forum but could find a solid answer. ı'm planning to do a pot controlled boost table . On the software no problem i arranged the table by An V1 (which is selected as 0-5V input and calibrated to 0-5v % 0-100 ) But i couldn't find answer which rate of ohm to use in An V1 to arrange it between 0-5 V I think it is 1k ohm but i can not be sure. thank you Quote Link to comment Share on other sites More sharing options...
Simon Posted July 11, 2013 Report Share Posted July 11, 2013 A pot in the range of 1k to 4k7 will be fine you dont want to go much lower than 1K as it will start to get a bit warm. Wired in the sam way as you would a TPS input. Quote Link to comment Share on other sites More sharing options...
spawn_CA18 Posted July 11, 2013 Author Report Share Posted July 11, 2013 thank you simon , i prepared the pot and installed already. which pins to use in CA18 short header as +5 source and signal ground? i see there is on expansion but i dont have expansion cable. Quote Link to comment Share on other sites More sharing options...
spawn_CA18 Posted July 12, 2013 Author Report Share Posted July 12, 2013 i found TPS 5 V signal on ecu connector . if i use it does my pot works as voltage divider or works properly? either i couldn't find any other 5V on ecu connector Quote Link to comment Share on other sites More sharing options...
spawn_CA18 Posted July 12, 2013 Author Report Share Posted July 12, 2013 Done !... http://youtu.be/7dzbc7Jx2XM Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.