Patches Posted July 26, 2022 Report Share Posted July 26, 2022 Just wanted to double check something, I'm fitting a Brantz BR3 Gearbox Speed Sensor to my Link G4+ Fury and the supplied wiring is unshielded it appears. I was going to cut the really long cable much shorter and run a 3 way DTM connector but my question is... Should I use shielded wire for this? (+5v, Sensor Ground, Sensor Signal) if so how many cores, 3? Or is it only important to shield the signal wire? Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 26, 2022 Report Share Posted July 26, 2022 No, VSS are rarely shielded, usually only ABS sensors. Quote Link to comment Share on other sites More sharing options...
Patches Posted July 26, 2022 Author Report Share Posted July 26, 2022 45 minutes ago, Adamw said: No, VSS are rarely shielded, usually only ABS sensors. Thanks Adam! I had originally cut regular wire and just as I'm about to start splicing I started to doubt myself. Spent an hour googling and searching the forum before I created this post. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.