VegasAWD Posted September 17, 2022 Report Share Posted September 17, 2022 I have the VR4+ plug-in ecu. I had a new harness made with a switch to sequential ignition (ign on pins 54,55,56,57) and will be running AEM smart coils. Of course I'll have to edit the ign outputs to correct pins. 1) For setup, I'm assuming I need to change ignition to sequential, spark edge to Falling. Is there anything else I'll need to change in PCLink? 2) Can anyone recommend a dwell table for me? I have no idea where to start? I won't be pushing the coils at all so I would need just a basic recommendation for a 4g63. Thanks for any help. Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 17, 2022 Report Share Posted September 17, 2022 3 hours ago, VegasAWD said: For setup, I'm assuming I need to change ignition to sequential, spark edge to Falling. Is there anything else I'll need to change in PCLink? That is all. 3 hours ago, VegasAWD said: Can anyone recommend a dwell table for me? I have no idea where to start? I won't be pushing the coils at all so I would need just a basic recommendation for a 4g63. You likely wont need much. Set it initially to 2.5V at 14V and say 2.8ms at 13V, 4ms for all voltages below 13. Quote Link to comment Share on other sites More sharing options...
VegasAWD Posted September 17, 2022 Author Report Share Posted September 17, 2022 3 hours ago, Adamw said: That is all. You likely wont need much. Set it initially to 2.5V at 14V and say 2.8ms at 13V, 4ms for all voltages below 13. Thank you sir! This look ok? Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 18, 2022 Report Share Posted September 18, 2022 Yep that will do it. VegasAWD 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.