Gaberpot Posted September 26, 2022 Report Share Posted September 26, 2022 Hey everybody, getting some finishing touches finalized and one thing I was trying to ensure works, was my momentary switch wiring for launch control. I’m using a tweaked engine harness, and it appears to use an volt 8 for the launch control input. I wired in my momentary switch from my launch control switch in my is300; 1 side to ground, other side to the ecm. It’s a normally open switch. whenever I enable the switch, I can see it sitting at .01 v and enabled drops to 0.. not really sure where to go from here.. if I check the active state to low side- it says it’s activated. And high side, says inactive but will not switch when enabled.. any input much appreciated, maybe I’m over complicating something simple. Thanks a bunch! Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 27, 2022 Report Share Posted September 27, 2022 it should be connected to a digital input. Gaberpot 1 Quote Link to comment Share on other sites More sharing options...
Gaberpot Posted September 27, 2022 Author Report Share Posted September 27, 2022 That’s what I had thought.. so it being connected to An volt 8, pin Just needs to be moved to a DI pin? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.