cameron350z Posted November 30, 2022 Report Share Posted November 30, 2022 I need help I do not know how to set it up after it is wired in not a clue I know how to connect to the ecu I have a pnp 350z g4+ and my car needs the wideband to drive without it, it is very rough as the data log will show locked steering.llgx Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 30, 2022 Report Share Posted November 30, 2022 Im not sure I understand your question? Do you need help to set up a wideband controller? What wide band do you have? How is it connected to the ecu? Can you attach a copy of your map. Quote Link to comment Share on other sites More sharing options...
cameron350z Posted November 30, 2022 Author Report Share Posted November 30, 2022 I need help setting it up in the ecu. I don't have a controller the g4+ is suppose to have it built in. I have the bosch 4.9 lsu and it connected with the expansion loom and what map? Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 30, 2022 Report Share Posted November 30, 2022 Only the Fury and Thunder have built-in wideband controllers, the plug-in ECU's dont. You will need a wideband controller for a wideband sensor. 12 minutes ago, cameron350z said: and what map? The map/tune/calibration/ecu configuration file. A .pclr file. Quote Link to comment Share on other sites More sharing options...
cameron350z Posted November 30, 2022 Author Report Share Posted November 30, 2022 okay that helps Quote Link to comment Share on other sites More sharing options...
cameron350z Posted December 29, 2022 Author Report Share Posted December 29, 2022 do you know which color is can L and H in the expansion loom Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 29, 2022 Report Share Posted December 29, 2022 CAN is not on the expansion loom, there is a separate 5pin socket inside for CAN 1. Quote Link to comment Share on other sites More sharing options...
cameron350z Posted February 16 Author Report Share Posted February 16 okay I have got a bunch of other link products to make it fully plug to plug and the wideband doesnt get a signal I have The link can connection jst for my ecu pcb the link can extension I have the link cantee and I have the link controller with the link wideband thats my latest ecu map with an updated firmware 350 upfwu.pclx Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 16 Report Share Posted February 16 There is no CAN set up for the lambda module(s) at all and lambda 1 is still set to AN Volt 10 and Lambda 2 is set to AN Volt 11. Set-up instructions from the help file below: Quote Link to comment Share on other sites More sharing options...
cameron350z Posted February 16 Author Report Share Posted February 16 that helps having the two sources Ill check i have both on Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.