Steve Bull Posted February 19, 2023 Report Share Posted February 19, 2023 Did the latest up date for the g4x xterme. It fly by wire, afterwards i noticed my throttle on start up was 3%, normally it was on 9% before the engine started and was cold. On trying to calibrate the TPS it keep coming up with errors. I can here the throttle clutch switching on and the throttle moving but the TPS reading doesn't change. Any ideas Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 19, 2023 Report Share Posted February 19, 2023 1 hour ago, Steve Bull said: i noticed my throttle on start up was 3%, normally it was on 9% before the engine started and was cold. What was the E-throttle target? 1 hour ago, Steve Bull said: On trying to calibrate the TPS it keep coming up with errors. I can here the throttle clutch switching on and the throttle moving but the TPS reading doesn't change. Any ideas Can you give us a hint? What error? A log and tune would be useful too. Quote Link to comment Share on other sites More sharing options...
Steve Bull Posted February 19, 2023 Author Report Share Posted February 19, 2023 I didnt know if the upgrade had altered or any settlings need to be recalibrated, as sometimes happens. Its not registering the throttle movement or power going to Aux 9/10. APS reads correctly, it just that ill all worked prior to the upgrade, then didnt the second it rebooted. Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 19, 2023 Report Share Posted February 19, 2023 19 hours ago, Adamw said: A log and tune would be useful too. Quote Link to comment Share on other sites More sharing options...
Steve Bull Posted February 19, 2023 Author Report Share Posted February 19, 2023 ill do it tomorrow Quote Link to comment Share on other sites More sharing options...
Steve Bull Posted March 10, 2023 Author Report Share Posted March 10, 2023 Finally got time on the car today.....And it's fixed itself. Fly by wire found, calibrated, working and doing its stuff....Must have been a Pixey issue and they fixed it. Quote Link to comment Share on other sites More sharing options...
Steve Bull Posted March 15, 2023 Author Report Share Posted March 15, 2023 Trying to do some CAN. If you sending "Generic dash" on one of the channels. Do you still have to go to streams and load stream "generic dash" to that stream. Or is this done automatically under Mode tab, Data heading and selecting "Generic dash" in the mode box. CAn more than one CAN device receive the same channel and CAN ID. All it is i need the Haltech ic-7 dash and Hardwire pdm to get the same data. It does work at the moment fairly well, with two generic dashes being sent on different channels/CAN ID. But its a bit messy and all the channel are being used. Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 15, 2023 Report Share Posted March 15, 2023 You dont need to load a stream, just set the mode to transmit generic dash. All devices on the bus can read the same stream, you dont need to set up two. Having said that I dont think generic dash would be very useful to a PDM anyhow, typically for a PDM you would just send a few CAN auxes for things like fuel pump request, fan request etc. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.