V Fenech Posted April 29, 2023 Report Share Posted April 29, 2023 I need some advise about the spark edge. I have 2 channel igniter and the Ignition coil pack is MSD part number 8240. Can somebody tell me what I need to use in the spark edge Falling or Rising ?? Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 29, 2023 Report Share Posted April 29, 2023 You will want falling edge for that. Quote Link to comment Share on other sites More sharing options...
V Fenech Posted April 30, 2023 Author Report Share Posted April 30, 2023 Thanks Adam, I used Falling as you said. I have an issue regarding Misfire about 6000 RPM. I noticed in the logs its making ignition cut but the RPM limit is not becoming active, even yhe trigger is 0 count. The RPM limiter is set at 8300 RPM and the limiter range is 300 so the engine is not reaching the limiter. In the trigger 1 the arming treshold is: 3 at 5000 RPM, 3.5 at 6000 RPM, and 4 at 7000 RPM What do you suggest I should look for please ?? Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 30, 2023 Report Share Posted April 30, 2023 Attach a log showing the problem and a copy of the tune and I will have a quick look if there are any clues. Quote Link to comment Share on other sites More sharing options...
V Fenech Posted May 2, 2023 Author Report Share Posted May 2, 2023 These are the logs where it shows the problem and a copy of the tune r1.llg R6.llg MISFIRE.pcl Quote Link to comment Share on other sites More sharing options...
V Fenech Posted May 4, 2023 Author Report Share Posted May 4, 2023 Hi Adam, have you seen the logs yet please ? Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 5, 2023 Report Share Posted May 5, 2023 Launch control is active. Your launch control activation conditions are set up for Speed < 30kmh AND DI4 = ON, both are true where to launch limiter is working. I see DI4 is switching on and off a lot in the log so possibly you have a bad switch? Quote Link to comment Share on other sites More sharing options...
V Fenech Posted May 5, 2023 Author Report Share Posted May 5, 2023 Thanks for your reply I will check the switch as you suggested tomorrow and I will let you know.... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.