DOLFO Posted July 20, 2014 Report Share Posted July 20, 2014 Hi, I’m looking for a setup for a minimum time between gear changes for gear cut control (V44 ECU). I want to prevent false triggering on the gear cut. Right now sometimes my bike double shifts when press/depress the shift button. I’m thinking with virtual aux with timer or something like to get some delay before next shift. If I push the button twice that it will prevent the bike to shift again. Any suggestions are welcome! Thanks, Dolfo Quote Link to comment Share on other sites More sharing options...
Simon Posted July 21, 2014 Report Share Posted July 21, 2014 As you need to use a Di as the input for the cut, I think the only option to allow a timer would be to use a Aux out to trigger the Di. The switch conditions for the Aux out can then be based off the Switch input and a timer condition. The issue with this is it could introduce excessive delay to the cut response. Quote Link to comment Share on other sites More sharing options...
DOLFO Posted July 21, 2014 Author Report Share Posted July 21, 2014 Hi Simon, thanks for your reply! That's not ideal if it will cause a delay to the cut response. Is there any other way to accomplish this? Is this maybe an idea for the next firmware upgrade where there is a delay before next shift cut signal in the gear cut control. Quote Link to comment Share on other sites More sharing options...
Simon Posted July 22, 2014 Report Share Posted July 22, 2014 It might not be enough to be a problem but it is untested. Gear cut is an area that will undergo a rework in the future for the i Series units. Quote Link to comment Share on other sites More sharing options...
DOLFO Posted July 22, 2014 Author Report Share Posted July 22, 2014 Simon, can you break down the logic for me to use a timer in this setup? I will give it a try at the next race to see if there is any extra delay in the cut. Thanks. Quote Link to comment Share on other sites More sharing options...
Simon Posted July 23, 2014 Report Share Posted July 23, 2014 This is what I'm thinking should work. Di 1 is your activation input from the bike. Aux output 4 is looped in to Di2. You will then use Di2 to activate the cut. With the set up as pictured the shift cut should not be able to happen with in 1 second of the last. You can reduce this time by lowering the timer 1 value in Aux 4 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.