lee mc Posted July 1, 2023 Report Share Posted July 1, 2023 hi, i have a link fury connected to a aim pdm32 i have the ecu steam setup. dash is all reading correctly but was looking to switch on fuel pumps and fans through can, there doesn’t seem to be any preconfigured can till do so. do i have to set up a different can stream on the ecu stream or wire in a second can network? Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 1, 2023 Report Share Posted July 1, 2023 You will need to send a user stream from the ecu with the extra channels you need and a custom receive at the pdm end. If you attach a copy of you ecu and PDM configs I will set up the basics. Quote Link to comment Share on other sites More sharing options...
lee mc Posted July 2, 2023 Author Report Share Posted July 2, 2023 hi adam thanks for your reply. that would be get ill link below thanks lee s15 rb26.pclr pdm32 s15 rb26.aimcfg Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 2, 2023 Report Share Posted July 2, 2023 That's not the pdm config, it should have a .zconfig extension. Go to the configuration page in RS3, put a check in the checkbox for your PDM then click the export button. Quote Link to comment Share on other sites More sharing options...
lee mc Posted July 3, 2023 Author Report Share Posted July 3, 2023 PDM32 s15 rb26.zconfig Quote Link to comment Share on other sites More sharing options...
lee mc Posted July 4, 2023 Author Report Share Posted July 4, 2023 i have linked the pdm configuration above Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 4, 2023 Report Share Posted July 4, 2023 Sorry for the delay. Attached are your ECU and PDM configs, in the ECU I moved the fans and fuel pumps to virtual auxes and these are all sent to the PDM, as well as aux 8 for the e-throttle relay. In the PDM I have set up two buttons on the keypad just as examples for high boost and ALS, and set up the PDM to send these out to the ECU, they will be received as CAN Dig 1 & 2. The setup of this CAN output you will find in the CAN output tab in your PDM config. The custom CAN for the fuel pumps etc is sent out of the ecu as a separate user stream but at the AIM end it is all set up to be received as part of the main "ECU stream", you will find these new channels down the bottom of the ecu channels list. The 3rd file attached here with the .xc1 extension is the custom "ecu protocol"/CAN template, you dont need this file to make anything work, but you can import this template into RS3 CAN builder area to see how it is done or if you want to add anything to it later. PDM32 s15 rb26 V2.zconfig LINK_Lee MC_@20230704_104109_003161.xc1 s15 rb26 V2.pclr Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.