Use CAN BUS message as input.

[Simon_s13]

Hi I’m running a link Extreme G4+ and I am trying to use a can message as an input to activate and deactivate the launch control and traction control. I believe that the G4+ does not allow me to do it but I like to ask if it will be possible.

 

I have created the message already

 

ID 1100 

B0 : traction control

B1: launch control

 

[Adamw]

There is a native "traction disable sw" CAN input, assign this to byte 0 (start pos 0, width 8), for launch in byte 1 (start pos 8, width 8) receive it into one of the CAN Dig inputs, then assign this as your launch activation control.

[Simon_s13]

On 7/4/2023 at 1:02 AM, Adamw said:

There is a native "traction disable sw" CAN input, assign this to byte 0 (start pos 0, width 8), for launch in byte 1 (start pos 8, width 8) receive it into one of the CAN Dig inputs, then assign this as your launch activation control.

Thanks Adamw all is working now