taku Posted July 13, 2023 Report Share Posted July 13, 2023 I'm trying to make it a 4 throttle at Altezza. Do you know how to set the wiring of the accelerator position sensor and the LINK side? Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 13, 2023 Report Share Posted July 13, 2023 Can you explain with a bit more detail, I dont understand the question well. Are you using an Altezza plug-in ECU or a wire-in ecu? Are you fitting ITB's and you want them operated by an electronic throttle actuator? Quote Link to comment Share on other sites More sharing options...
taku Posted July 13, 2023 Author Report Share Posted July 13, 2023 I want to change from electronic throttle type to wire type throttle. Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 13, 2023 Report Share Posted July 13, 2023 If you are changing to a cable throttle you will no longer need an APS (pedal sensor), just a single TPS sensor on the throttle bodies. This can be connected to the original signal wires from the electronic throttle or you can connect to any other spare AN Volt input. In the software set E-throttle 1 mode to off and assign the Throttle position sensor source in the analog inputs menu. Quote Link to comment Share on other sites More sharing options...
taku Posted July 14, 2023 Author Report Share Posted July 14, 2023 Thank you. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.