Slowkid Posted July 21, 2023 Report Share Posted July 21, 2023 Hi everyone, I hope somebody in this community can help me with the following issues The ECU is Thunder with the latest firmware update and the Dash is AIM 7 inch MXG 1.2 strada. my problem is 1. The Fuel pressure reading on the Dash is not the same as shown on my PC Link, somehow seems 10x smaller. 2. Are there any pre-configured CAN data stream specifically for Thunder ECU as I would love to see my EGT reading on Dash. Any help highly appreciated Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 21, 2023 Report Share Posted July 21, 2023 The fuel press scaling was fixed several years ago. On the ecu stream tab in rs3, check you have v2.00.07. If not, click on change ecu, then just select the same CAN BUS BASE LCC ecu and it will reload the latest Quote Link to comment Share on other sites More sharing options...
Slowkid Posted July 21, 2023 Author Report Share Posted July 21, 2023 3 hours ago, Adamw said: The fuel press scaling was fixed several years ago. On the ecu stream tab in rs3, check you have v2.00.07. If not, click on change ecu, then just select the same CAN BUS BASE LCC ecu and it will reload the latest Thanks ADAM, worked like a charm. what about EGT reading from the ECU, possible to configure? Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 23, 2023 Report Share Posted July 23, 2023 That will need a custom stream added. If you attach a copy of your tune and dash config I can set it up. Quote Link to comment Share on other sites More sharing options...
Slowkid Posted July 24, 2023 Author Report Share Posted July 24, 2023 17 hours ago, Adamw said: That will need a custom stream added. If you attach a copy of your tune and dash config I can set it up. Thank you Adam for the response. I have actually found some file from earlier post in this community for Thunder ECU, I imported the CAN protocol and play around with it. Manage to get data stream specific to the ECU like EGTs but the reading is NOT displayed as what seen on my PClink. I am not sure if any specific setup on the Data stream is required. Thanks any help is highly appreciated. Thunder G4+ slowkid.pclr Thunder G4+ slowkid with ICONS.zconfig Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.