点火試験では発火しますが、クランキング中は発火しません。CRX B16A(OBD0)

[Daiki]

Nice to meet you
I am installing monsoon on my CRX B16A.

I removed the distributor cap and did a spark test to make sure it was firing from the coil.
There is a spark.

After that, even when I cranked it, it wasn't firing from the coil. No spark.

Ignition 1 is active. However, there is no spark from the coil and it is not ignited.

Triggers 1 and 2 are set to [yes] during cranking.
Rotational speed is about 200rpm.
Dwell time is 3.5ms.
tooth count=16(OBD0)
The battery voltage is around 10.5V during cranking.

Do you know what caused it?
thank you.

[Vaughan]

Can you attach a Trigger scope, a PC log from when you are cranking it and a copy of your tune please.

[Daiki]

2 hours ago, Vaughan said:

Can you attach a Trigger scope, a PC log from when you are cranking it and a copy of your tune please.

Thank you

Here you will.
Trigger 1 also tried +/- reverse.

[Vaughan]

Please attach the actual files, not just a picture

[Adamw]

And a copy of the .pclx ecu file would be useful also.  

[Daiki]

I'm sorry,It was a simple mistake not to fire.

I didn't assign and wire the ignition switch to DI1 even though I didn't use it.

Because of that, the ignition cut was 100% and it was Engine kill Active.

When I turned off the ignition switch of DI1, it started to ignite when cranking.

I adjusted the trigger offset and started the engine.

thank you.