AP1 Posted August 12, 2023 Report Share Posted August 12, 2023 Hello, I need some help because after wiring and setup the can protocol between thunder ecu and aim mxs strada light dash, following the aim help file, the dash still not display ecu values. I have the last firmware I have connected directly on thunder ecu can+ on pin D24 and can- on pin D25 Does the thunder ecu as a 120ohm internal resistor between theses two pins? thanks Antoine Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 12, 2023 Report Share Posted August 12, 2023 The ID should be 1000 assuming you have the dash set to "CAN BUS BASE LCC". Yes the ECU has an internal termination resistor on both busses. Quote Link to comment Share on other sites More sharing options...
AP1 Posted August 12, 2023 Author Report Share Posted August 12, 2023 Thanks Adam, i try to change the ID number and let you know Quote Link to comment Share on other sites More sharing options...
AP1 Posted August 14, 2023 Author Report Share Posted August 14, 2023 Thanks that's was it Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.