Willie Posted August 25, 2023 Report Share Posted August 25, 2023 Hey there I have just bought 2 x old link ecus 1 is g1 link plus and the other is g2 link plus was just wondering what they are set up for I would like to run the g2 on 2jz non vvti with cam and crank trigger.https://photos.app.goo.gl/c1ER7GkJzMQVyUqHA Can anyone identify what sub boards etc they have ? Many thanks William Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 25, 2023 Report Share Posted August 25, 2023 The G1 has a standard reluctor board in it, so this would be for an engine that has a 1 tooth per TDC trigger with a reluctor sensor on both trig 1/2. For example a 4AGE or honda with the 4 tooth dizzy. The purpose of the sub-board in the G2 is a bit different. The trigger decoding and trigger offset etc in the G2 is done in software like more modern ecu's. The subboard in this case is only used to condition the raw trigger signal into a nice filtered square wave. Your G2 has a hall/opto sub-board in it so it can be used on any engine that has 2 hall sensors and is supported in the trigger mode settings in the software. Quote Link to comment Share on other sites More sharing options...
Willie Posted August 26, 2023 Author Report Share Posted August 26, 2023 Hey thanks for fast reply I appreciate your information and help Many thanks William Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.