Romain66 Posted March 17 Report Share Posted March 17 Good morning sorry for my English I'm French I bought an aim fuel level sensor can you help me configure it in the strada 1.2 dashboard? for calibration? possible to have the information in % or in liters? Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 17 Report Share Posted March 17 See if this document helps: https://www.aim-sportline.com/download/faqs/eng/hardware/sensors/mx_series/FAQ_Sensors_MXx12_StradaSpieIcone_100_eng.pdf Connection is described on page 3, and software set up on page 10 & 11. Another doc with slightly more detail of software setup: https://www.aimsports.com/webinars/Documents/FAQ_RS3_Fuel_level_101_eng.pdf If anything is not clear to you after following these documents then reply here and I will try to give more specific help. Quote Link to comment Share on other sites More sharing options...
Romain66 Posted March 25 Author Report Share Posted March 25 Hello Adam I connected a VDO probe Empty 465 mv tank full tank 160mv I have I did a pullup with an 830 ohm resistor can you tell me if the resistance is good? or if I also have to put a capacitor? will you have the cable please? for the dash strada Quote Link to comment Share on other sites More sharing options...
Romain66 Posted March 26 Author Report Share Posted March 26 Adam ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.