JamieZx Posted March 19 Report Share Posted March 19 how do I change my rpm limit and how can I change the degrees in the 24 psi range a video will help Z32 TUNE.pclx Quote Link to comment Share on other sites More sharing options...
k4nnon Posted March 19 Report Share Posted March 19 8 hours ago, JamieZx said: how do I change my rpm limit and how can I change the degrees in the 24 psi range a video will help Z32 TUNE.pclx 460.46 kB · 2 downloads Your RPM Limit table is under the Engine Protection tab. You should be able to open up the table and adjust your rpm value at any specified coolant temp. As for degrees, I assume your talking about ignition? The ignition table is under the Ignition tab and you can adjust the table to fit your particular boost values. Not sure if any of that helps. The Link help section is also great for info as well. Best of luck. Quote Link to comment Share on other sites More sharing options...
JamieZx Posted March 19 Author Report Share Posted March 19 so if the rpm is at 5350 I just adjust it to 7400 ? nothing else? Quote Link to comment Share on other sites More sharing options...
k4nnon Posted March 19 Report Share Posted March 19 9 hours ago, JamieZx said: so if the rpm is at 5350 I just adjust it to 7400 ? nothing else? yes. say the engine is fully warmed up and 190 degrees F. or so. and in that cell the rpm is 5500. well if the coolant is 190 then it wont allow any more rpm then 5500. so just raise the rpm value to whatever you would like to run. this is a limiter so if you want to run 8k i would set the limiter at like 8600. this allows the full use of 8k but has the soft limiter and hard limiter soon after for the safety feature. Quote Link to comment Share on other sites More sharing options...
JamieZx Posted March 20 Author Report Share Posted March 20 4 hours ago, k4nnon said: yes. say the engine is fully warmed up and 190 degrees F. or so. and in that cell the rpm is 5500. well if the coolant is 190 then it wont allow any more rpm then 5500. so just raise the rpm value to whatever you would like to run. this is a limiter so if you want to run 8k i would set the limiter at like 8600. this allows the full use of 8k but has the soft limiter and hard limiter soon after for the safety feature. thanks man Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.