rotary renisis won't idle

[peter1436215447]

I have a rotary renisis in vw beetle,the problem is i can't get it to idle up even steping up the rpms it might be ok for a very short time but then returns back to what it was,i have even screwed up the idle on the thrittle boady and along with tps.It feels to me that it could be too rich,i had the tune set up by a garage that did the conversion. Peter

[Dtech Motorsport]

can you email the tune? and a discription of the setup ecu used fuel system etc, Is the oil system used or are you premixing the fuel?

Has the engine been tuned ?  have you taken the vehicle back to the shop that did the work?   did they have any suggestions?

 

Regards

Dave

[email protected]

 

[peter1436215447]

Hi Dave, Attatched is the last tune application,I hope you are able to open. I have a G4 extream., Regards, Peter

[Dtech Motorsport]

are you running 6 injectors?

The idle control is selected as a solenoid  this can only work between 0-100%  100% is full on it has numbers at running temp of 250-380  i would suggest this vehicle gets looked at again by a tuner

where abouts in nsw are you ?

Regards

Dave

[email protected]

 

[peter1436215447]

Hi Dave, Iam located in Uralla NSW 15min south of Armidale and 1 hr north of Tamworth, Regards, Peter

[Phil Williams]

Peter,

From looking at where you are on the map, we have Advan in Sydney and K-Tune in north Brisbane.

Advan Performance Centre

28 Hamstead Road, Auburn, Parramatta, NSW 2144

Tel +61 2 9648 3366, Fax +61 2 9648 0741, Parts Direct +61 2 9647 1868

http://www.advan.co.nz/

K-Tune

5/8 John Duncan Court, Varsity Lakes, Gold Coast, QLD 4227

Tel: +61 7 5522 1115