team claymore Posted June 12 Report Share Posted June 12 I have followed the instructions and just want to see what you think about this trigger scope pattern. using no shim what are your thoughts? Will this work? also why cant i see my trigger 1 scope on triggers, its only visible when i select trigger 1 state. If this looks ok to you i will move onto base timing setup and offset. Thanks again Trigger Scope - zero shim.llgx Quote Link to comment Share on other sites More sharing options...
Vaughan Posted June 12 Report Share Posted June 12 Your wires are the wrong way around, not the first time I have seen this and it isn't unusual for the instructions to be wrong on this. Regarding shim amount that voltage looks fine for getting sync. Quote Link to comment Share on other sites More sharing options...
team claymore Posted June 12 Author Report Share Posted June 12 Ok thanks, here is the scope with wires switched around, would you consider this correct and ready to move forward? Trigger Scope - zero shim polarity reversed.llgx Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 12 Report Share Posted June 12 Yeah that looks usable, they always look a bit shit at cranking speed but it will likely look much better when it starts. Try the offset around 90deg if it is a yelsha D one. team claymore 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.