Ash Posted January 8, 2008 Report Share Posted January 8, 2008 Greetings All, I have a link G3 plugin in my wrx sti Version 8. the IAT (Inlet air temperature) reading always stays at 20 degrees with no movement at all. Using pclink V3.32 with firmware V1.5.1. Analogue channel --> AN Temp4 set to Inlet Air Temperature Temp sensor type set to Std Bosch NTC. These are the defaults with the wrx STI plugin. Any ideas? Regards Ash Quote Link to comment Share on other sites More sharing options...
Ash Posted January 9, 2008 Author Report Share Posted January 9, 2008 Ok, solved my own problem - no worries. Had to set the sensor up on AN Temp2 ..works fine Regards Ash Quote Link to comment Share on other sites More sharing options...
Arts Posted April 18, 2008 Report Share Posted April 18, 2008 i have same problem only version 4 car. AN Temp2 IAT reading always stays at 20 degrees. even if the wire is not connected, i mean IAT sensor. Quote Link to comment Share on other sites More sharing options...
Simon Posted April 21, 2008 Report Share Posted April 21, 2008 Hi Ash Good to see you got it sorted. Arts The IAT will default to 20 if no sensor is connected. I would be tracing the wiring through and checking the adapta jumper settings if you are running one. Simon Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.