Roger1436215387 Posted February 9, 2013 Report Share Posted February 9, 2013 Looking for some help, i decided to do a firmware upgrade, it brought up a box, asked if i wanted to update from 4xx to 49 so i pressed the y button. it said the ecu would go offline to carry out the upgrade then in the box it came up and said the usb was configured to the wrong com port - change and try again. so i tried but now there is no friendly blue light on the ecu and the searching icon flashes from green to red and wont connect. Is there something i can do or have i just made a paper weight? there still appears to have a 5v signal output voltage but engine wont run. Thanks.... Quote Link to comment Share on other sites More sharing options...
Simon Posted February 10, 2013 Report Share Posted February 10, 2013 Do you have a Dash connected to the serial port? If so make sure it is unpluged at the ECU end. Also check in device manager to see if the ECU is being recognised and if it is assigning a com port number. I have also emailed you a link to some pre release firmware/software to try. Quote Link to comment Share on other sites More sharing options...
Roger1436215387 Posted February 10, 2013 Author Report Share Posted February 10, 2013 No dash is installed, i removed a microtech system and installed a g4rx, so it has been a complete re installation using new sensors and loom etc. i did try the change comport thing in device manager but nothing. i have downloaded that file from the link you gave so i'm on my way into work to give it a go! Quote Link to comment Share on other sites More sharing options...
Roger1436215387 Posted February 11, 2013 Author Report Share Posted February 11, 2013 Thanks Simon, all up and running now! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.