Chris Leigh Posted June 7, 2009 Report Share Posted June 7, 2009 Hi, Recently my cars developed a fault that occurs around 2 minutes or so after starting the ignition. The DisplayLink will fully black out (all the LEDs fully light up) and the backlight will brighten. The car then idles erratically, anywhere between 1,000RPM and 2,000RPM, and doesn't respond to throttle inputs; the car stalls when given any gas. Anywhere between 10 seconds and a minute or two later the car will revert back to normal and run fine. In the same journey it'll sometimes repeat, but usually without the stalling just no boost being allowed. Does anyone have any ideas? The various connections and sensors wired into the car all appear fine. Thanks in advance, Chris Quote Link to comment Share on other sites More sharing options...
Simon Posted June 9, 2009 Report Share Posted June 9, 2009 I would be looking at things like a loose battery terminal. Also check all the power supplies and grounds to the ECU. Quote Link to comment Share on other sites More sharing options...
cole watson Posted June 29, 2009 Report Share Posted June 29, 2009 flyin miata use a different wire to ground the ecu i have done this with no problems try it http://www.flyinmiata.com/support/instructions/ecu/1.6L_Link_ECU_installation.pdf check out page 6 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.