[email protected] Posted June 17, 2015 Report Share Posted June 17, 2015 Hi, Is it physically possible to have CAN activated on a G3 that has been upgraded to G4? Â The board has the white 5 way connector sockets on it, one labeled CAN, so I was hoping to stream data to an Omega D4. Â Cosworth sent me the G4 CAN interface and since I'm running out of AVs on the dash, I would love to get rid of two sets of engine sensors and just stream engine homeostasis through the bus if possible. Â Thanks for any help. Quote Link to comment Share on other sites More sharing options...
[email protected] Posted June 17, 2015 Author Report Share Posted June 17, 2015 I should add that it is a G3 PCB Version 1.2, Chipset is Serial # 2645 and it was upgraded from G3 to G4 firmware/software. Quote Link to comment Share on other sites More sharing options...
Simon Posted June 17, 2015 Report Share Posted June 17, 2015 Hi Bill  Yes it is an option but it will need some hardware changes to suit. We will need to do the hardware mods inhouse so will need to see the unit. Quote Link to comment Share on other sites More sharing options...
Simon Posted June 19, 2015 Report Share Posted June 19, 2015 Typically 1-3 days Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.