Jump to content

Recommended Posts

Posted

Hello, hope someone can help. i have read my installation notes and in one section it says the G4 needs resistors installed if low impedance injectors are fitted but if you use the RX G4 (which i am) it says you can wire them up as 'normal'.

i have bought some new delphi 95lb injectors - mainly because they are listed in the injector setup menu - and i was going to wire up without resistors until i measured the resistance -2ohms. In the instructions it says 3ohms is very low, so my question is this, can i use these without resistors or will i be putting too much load on the ECU?

Thanks!

Posted

On the RX ECU that will be fine to drive those injectors direct.

On a Storm or Xtreme they would require ballasts.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...