G4 Gtr plug in with 500r Autronic cdi

[Aaron Cuddy]

Is it possible to wire a plug in Gtr g4 with a Autronic 500r cdi is so does anyone have a wiring diagram 

[Scott]

Hi Aaron,

Here is a wiring diagram I found:

http://www.mrm-racing.se/bag/DFCDI%20BASIC%20WIRING.pdf 

Connect your G4 Ign outputs to where it says 'IGN ECU O/Ps'. It is probably a good idea to flatten your ignition dwell table to about 3ms everywhere.

Cheers,

Scott

http://www.mrm-racing.se/bag/DFCDI%20BASIC%20WIRING.pdf'>

[Aaron Cuddy]

So on the Gtr ecu pin outs is it 1,2,3 or 11 ,12,13 

Cheers

[Dave Kriedeman]

Is your 500R CDI a HF series.

If it is a HF series you can configure the output of the CDI to be Single Spark or Multi Spark Output by using the dwell table.

I normally run multi spark upto around 3000 RPM and then switch to Single fire from there to redline, depending on the application.

[Dave Kriedeman]

Forgot to mention,

ground the power select wire to put the 500R into High Power Mode or alternatively  you can setup an Auxillary output to ground the Power select wire at a given Parrameter

EG:   4500 RPM and 150 KPA