Niklas Adolfsson Posted July 7, 2013 Report Share Posted July 7, 2013 Hi, I have a Impreza STI V9 with a plugin G4 ecu, but I have a problem. I am out of Digital inputs and need just one more to activate antilag. I bought the expansion connector, but realized that the DI7 and 8 are not avaiable. Can I use a analog input together with and virtual aux? What is the best way to do that? Will it work if I take the expansion +5V and run it through a switch and back to AN volt 6. And then setup AN Volt 6 as a GP input with CAL 6-table. Cal 6 I set to A 0V and B 5V, output units None, output A 0, B 1. Then configure Virtual aux 1 and GP Output, Cond 1 only, AN V6 > value 1. Then under Antilag I choose Virtual Aux 1 for arming. Will it work? Did I do something unnecesary? No problem routing the +5V supply to An volt 6 without any load?   Quote Link to comment Share on other sites More sharing options...
Niklas Adolfsson Posted July 7, 2013 Author Report Share Posted July 7, 2013 I see I also can setup AN volt 6 to voltage measurement. Then I just have to put a voltage value between 0 and 5volts in Virtual Aux 1 to activate it when I flick the switch. Do I think correcty? Quote Link to comment Share on other sites More sharing options...
Simon Posted July 8, 2013 Report Share Posted July 8, 2013 Yep that would work. You will need to turn the fault settings off by setting the error high to 5V and low to 0V Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.