tasos triantafillidis Posted July 26, 2011 Report Share Posted July 26, 2011 hi,i'd like to help me with the rpm limit.my current settings are hard limit off,cut effect adaptive,end cut 100%,start cut tp100% 60%,start cut tp low 30%,tp low 15%,exit decay rate 1%/20ms,limit ignition trim -2.with these settings tha limit is very hard.i want to make it smoother and very soft.what should i change to settings,and what can i change after that to make it harder if it can't hold the rpm that i want??thank you in advance. Quote Link to comment Share on other sites More sharing options...
Simon Posted July 27, 2011 Report Share Posted July 27, 2011 Hi Could you post your full PCL (map) file. As there have been a few versions of limiting over different firmware. Quote Link to comment Share on other sites More sharing options...
tasos triantafillidis Posted July 27, 2011 Author Report Share Posted July 27, 2011 it is not the pcl that i use right now,but it's with the same firmware,only fuel and ignition maps have been changed. Quote Link to comment Share on other sites More sharing options...
tasos triantafillidis Posted July 27, 2011 Author Report Share Posted July 27, 2011 i tried to upload it but i can't. a little help please! Quote Link to comment Share on other sites More sharing options...
Simon Posted August 1, 2011 Report Share Posted August 1, 2011 It might be a better option to email it to [email protected]. That will get it to me. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.