motionper Posted April 1, 2014 Report Posted April 1, 2014 v twin odd fire- single coils spark on coil set up-if i remove the crank sensor and use a drill and bolt it registers on my screen but using starter no signal but the cam signal works is there a minimum crank speed setting??? Quote
Simon Posted April 3, 2014 Report Posted April 3, 2014 Cranking speed should be around 200 -250 RPM typically What do you have in the way of a crank sensor? Do you get a good RPM if you crank with the plugs out (no compression) Quote
motionper Posted April 6, 2014 Author Report Posted April 6, 2014 figured out my dilemma i am using a 60 tooth crank wheel and the unit doesn't like it, i have ordered a 24 tooth wheel from you and i think this will cure my problem- right now i have a 12 tooth and my square wave pattern is very poor my tooth width is only 3 mm and i think it may be to small my pattern looks more like a vss reluctor right now,i will keep you informed after i get the new trigger wheel Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.