William Grant Posted May 9, 2013 Report Share Posted May 9, 2013 I have a bigport 4age from a AE86 levin, and I am using a link V5e. I've had a browse through a lot of forums and havent quite found what I need just yet. I am having a bit of trouble wiring in both the TPS and igniter. Firstly the link manual says for the TPS i must use 3 wires, My factory TPS has 4 pins and I dont know which ones to use, I know one is ground but struggling to find out what the other 3 are for. Also the igniter has 5 wires in and Im stumped on what to do here, I plan on using a distributor setup using only IG1 on the LEM. So any info on this is greatly appreciated. Cheers, William Quote Link to comment Share on other sites More sharing options...
Simon Posted May 10, 2013 Report Share Posted May 10, 2013 This should help with the igniter wiring. http://www.linkecu.com/support/documentation/technical-drawings/I08 For the TPS you will have a power, a ground, a variable signal, and a on off switch (0 or 5V) http://s3.amazonaws.com/2cp-images/question_images/126331/large.jpg E2 being - Ground VTA is the TPS signal Vcc is 5V Quote Link to comment Share on other sites More sharing options...
William Grant Posted May 27, 2013 Author Report Share Posted May 27, 2013 Thank you for the quick response, If you could also shed some light onto the Distributor/ Cam angle sensor wiring would be greatly appreciated. I believe it is a "Optical /hall sensor" type distributor, so i have to use the +12V optical/hall sensor power supply wire along with Trig 2. Basically I need to know the pin out of the distributor wires so I know which wire goes where. Cheers, William. Quote Link to comment Share on other sites More sharing options...
Simon Posted May 28, 2013 Report Share Posted May 28, 2013 The 4AGE uses reluctor sensors so does not have a power supply. The two white wires need to be connected to the ECU ground or shield on the trigger wires. The other two give a trigger 1 signal and a trigger 2 signal. If wiring in a G1 LEM and are retaining the distributor you only need the one trigger that has 4 teeth. This is wired to trigger 1 input. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.