ed zahratka Posted August 11, 2015 Report Share Posted August 11, 2015 how do I wire triggers on a Toyota 5s fe ?has reluctor/magnetic sensors in distributorone 24 tooth and one 4 tooth. three wires coming out of distributor a black,red andwhite Quote Link to comment Share on other sites More sharing options...
Simon Posted August 12, 2015 Report Share Posted August 12, 2015 You have a couple of options.One is to use the 4 tooth trigger only and run group fuel and distributor ignition.The second is use the 24 tooth for trigger 1 and remove 3 of the 4 teeth and use the remaining single tooth as the trigger 2 input.This would be the better option as the resolution for ignition control is better and it allows sequential fuel. The common wire will be the sensor ground you will need to check which is the 24 and which is the 4/1 tooth. Quote Link to comment Share on other sites More sharing options...
ed zahratka Posted August 13, 2015 Author Report Share Posted August 13, 2015 THANKS for the info! does it mater witch teeth are removed? Quote Link to comment Share on other sites More sharing options...
Simon Posted August 13, 2015 Report Share Posted August 13, 2015 No any 3 of the 4 will be fine. Quote Link to comment Share on other sites More sharing options...
ed zahratka Posted August 28, 2015 Author Report Share Posted August 28, 2015 re-configured to sequential fuel injection,gound off three of the 4 pick ups. wired trigger one to white wire from dist. marked ne in wiring schematic,wired trigger 2 too the red wire from dist. marked G1 in schematics and remaining black wire from dist. to censer ground. then set trigger 1 to cam censer,24 tooth. set trigger 2 to crank x1.now reads rpm's runs great! thanks gain for the help! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.