ex-ctr Posted August 30, 2015 Report Share Posted August 30, 2015 Hi, I have installed a hall sensor kit to an SR20-vet conversion, do you have info on its setup. thanks Quote Link to comment Share on other sites More sharing options...
Simon Posted August 31, 2015 Report Share Posted August 31, 2015 I would assume it converts to a multi tooth trigger with a simple single tooth sync.But as to info I have none. Do you have a link to the kit or instructions for it? Quote Link to comment Share on other sites More sharing options...
ex-ctr Posted August 31, 2015 Author Report Share Posted August 31, 2015 I have the settings for Haltech ecu's bottom of istall guide http://www.taarks.com/v/vspfiles/Instruction_Manuals/200001_SR20ve_Hall_Sensor_Install_Guide.pdf Quote Link to comment Share on other sites More sharing options...
Simon Posted September 1, 2015 Report Share Posted September 1, 2015 For ours you would need to set asMulti ToothTrigger 1Opto HallTooth count 12Tooth position cam.Trigger 2Opto/hallSync mode cam x1 Falling edge for both triggers should work.Offset is an unknown. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.