bradn Posted September 2, 2015 Report Posted September 2, 2015 Hi all,Installed G4+ atom in a series 4 rx7, managed to start once using the S6 base map with some basic settings changed to make sure everything was reading fine and the triggers were setup properly, but was rough and cant seem to start again! Tried all deflooding procedures, even a tow start. Sparks tested against a strut bolt and also using a timing light to confirm when cranking. Definitely fuel there too. About the car, series 5 motor, GM MAP sensor, Delphi IAT , extended port everything else stock. If anyone had a series 5 base map or some tips to get it started that would be great! Then could get a proper run in tune. Quote
Simon Posted September 3, 2015 Report Posted September 3, 2015 Main difference with the Series 4 is the arming voltages for both triggers will need to be much lower.Otherwise the set up will be very similar. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.