Rob Posted June 4, 2016 Report Share Posted June 4, 2016 Good afternoon, I have had a Link G4 in my r32 for a while now and have just gone from an RB25/30 to an RB26 in my r32 gts4.The whole loom and drive line has been converted over.I'm currently running a Garrett T04z and would like to push the engine setup beyond the realms of the On board 1.5 bar map sensor.I would also like to do this without potentially having an aftermarket boost controller and just be able to run it directly from the on board computer.Is there a map sensor that I can upgrade too on the board itself?I do have an extension cable for the IAT that had to be mounted for the old setup, to which i no longer need for that for obvious reasons.My Link G4 is the equivalent to the Vipec V44, its a 2008 in it, maybe 2009, any and all help would be much appreciated. Thanks,Rob. Quote Link to comment Share on other sites More sharing options...
Rob Posted June 6, 2016 Author Report Share Posted June 6, 2016 Any help at all? Quote Link to comment Share on other sites More sharing options...
mikegt4dude Posted June 6, 2016 Report Share Posted June 6, 2016 You need an AN volt , an AN temp input, a map sensor and an IAT sensor. Heres some links to some sensors http://www.nzefi.com/products/engine-management/engine-management-sensors/map-pressure-sensors/http://www.nzefi.com/product/bosch-fast-response-iat-sensor-turbo-na/ Quote Link to comment Share on other sites More sharing options...
Scott Posted June 7, 2016 Report Share Posted June 7, 2016 We may be able to upgrade the on-board MAP sensor. Send an email to tech(at)linkecu.com with a link to this forum thread and we'll tell you what upgrade options are available and what the cost is.Scott. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.