Vapor Posted January 16, 2017 Report Share Posted January 16, 2017 Hi, I'm going to use G4+Storm for FD3S.I have been to make a configuration change 4 cycle to rotary.But in ignition tab could not display the trailling sprit map.All other units can display it when I had tried same configration change.Can't apply the trailling sprit map in rotary configration of G4+Storm? Quote Link to comment Share on other sites More sharing options...
Scott Posted January 16, 2017 Report Share Posted January 16, 2017 The G4+ Storm is able to support a rotary engine with a trailing split table. However as you have pointed out this table is not showing up when working offline. I will pass this on to the engineers, thanks for letting us know.Scott Quote Link to comment Share on other sites More sharing options...
Vapor Posted January 16, 2017 Author Report Share Posted January 16, 2017 Hi Scott,Thank you very much for your prompt reply and kind support notice.I look forward to fixing the issue.Vapor. Quote Link to comment Share on other sites More sharing options...
Scott Posted January 16, 2017 Report Share Posted January 16, 2017 I did find a work around solution. If you open the Black Storm sample map, then turn knock control off, then turn the engine mode to rotary the table should be visible.Scott Quote Link to comment Share on other sites More sharing options...
Vapor Posted January 16, 2017 Author Report Share Posted January 16, 2017 Hi,I could confirmed and tried your vest solution.Thank you very much for your kind support. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.