vers_us Posted April 2, 2017 Report Share Posted April 2, 2017 HI.I have a few questions about stock wiring and MAP, IAT and O2 wideband sensors.1) Could i use aftermarket MAP in place of stock?2) Could i use stock AFM signal wire at Volt1 as IAT signal with external pull-up?3) I have Innovate LC-2 installed. Could i use wideband singnal from LC-2 controller on stock ECU input? As i know stock ECU use narrowband signal.WBR. Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 3, 2017 Report Share Posted April 3, 2017 1) Could i use aftermarket MAP in place of stock?Yes. Just change the calibration in the analog input settings. 2) Could i use stock AFM signal wire at Volt1 as IAT signal with external pull-up?You could but it is probably easier to use ANTemp 4 which is available on pin 108. No resistor needed... 3) I have Innovate LC-2 installed. Could i use wideband singnal from LC-2 controller on stock ECU input? As i know stock ECU use narrowband signal.Yes, the stock narrow band input is just a normal analog input, you are free to connect any type of sensor you wish to it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.