Trigger offsets

[interprodave]

Hi ,

 I seem to be having problems adjusting the crank trigger offset ,the set up is 36-1 trigger wheel and no cam trigger .Trigger 2 is set to "none" engine sparks and has a injector duty but wont start .

Timing light is showing 110 degrees btdc

In the calibrate trigger section ,the trigger offset and the ref timing have a locked padlock which I have been unable to remove 

If I attempt Adjust the offset in the set basic timing section it always reverts to 0 

Any advise would be greatly appreciated 

Cheers Dave

[Adamw]

You need to do it in the "set base timing screen" and you need to hit enter after you change the offset value.  That should be all there is to it.