OGtrent Posted July 5, 2017 Report Share Posted July 5, 2017 Hi im new to the forum and to Link ecu's im currently wiring in a g4 storm to my engine harness using the factory harness Chopping oem ecu plug and removing the wiring i do not need for the engine to run im using the pc link download for most the info and a pinout from the nissan manual.looking through the pc link software i found the pin out section (pictured) now for my question is this a list of pins all that is required in the harness to run the vehicle as there are alot of pins missing/not listed when i was cross referencing the pinout i have (also pictured) thanks look forward to the answers Quote Link to comment Share on other sites More sharing options...
ClintBHP Posted July 5, 2017 Report Share Posted July 5, 2017 Yes is the answer you are looking for, you may also wish to cross reference to the Pin Functions in PCLink for that plug-in as they make more sense when looking at the OE loom.The way I do this is I only take the wires that are needed and terminate into the new header, I then make sure the ECU can see everything I want and then and only then do I remove the wiring I dont need.Did you realise the R34 Neo Plugin is on sale this month? - not a lot of use to you if you have already purchased the Storm. Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 5, 2017 Report Share Posted July 5, 2017 looking through the pc link software i found the pin out section (pictured) now for my question is this a list of pins all that is required in the harness to run the vehicle as there are alot of pins missing/not listed when i was cross referencing the pinout i have (also pictured) There is actually quite a bit more required than shown in our Pinout. I will send you a bit more info via PM. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.