Jump to content

Innovate MTX-L Plus wiring into spare AN Volt channel


ScoobydooJ
 Share

Recommended Posts

Hi,

I have a 2006 Sti with a G4 Plugin ecu installed. I have recently purchased a new wideband gauge and would like to wire the 5v output directly into the ecu. Looking at the pinout diagram, D25 (AnVolt7) is classed as wideband in my ecu. Same goes for AnVolt11. However, when I got the pinout diagram and actually looked for these wires, there is no physical wire on the car harness going into the ecu.  

I looked through the channels in the link software and I also have ANVolt 8 which is a spare channel. Could I therefore just splice into the wire, C23 that runs into the ecu and then assign it a calibration table? C23 does have a physical wire in the stock factory harness. 

Thanks in advance. 

John. 

20747034_10159159502850693_1461616732_o copy.jpg

20707230_10159159536215693_27825372_o.jpg

20726836_10159159544705693_1547825466_o.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...