trochoid Posted November 23, 2017 Report Share Posted November 23, 2017 Hi all. I'm running a Fury on a Mazda 20B 3 rotor using 500cc primary injectors and 6 1000cc secondaries. Is there a way to bring them in in 3 stages? i.e 3 then 6 then all 9 Many thanks in advance Quote Link to comment Share on other sites More sharing options...
Simon Posted November 23, 2017 Report Share Posted November 23, 2017 Auxiliary Injection Top Previous Next The Auxiliary Injection function allows Fuel Injection Drives 5-8 to be used for the controlled driving of additional injectors. Additional injectors may be used for the addition of fuel, nitrous or water. This is achieved by providing four independently configurable auxiliary injection channels. These channels have their outputs phased to engine position so will deliver one pulse per engine cycle. Each channel has a 3D table for tuning. The Auxiliary Injection Function also allows up to six stages of staged injection. Refer to the staged injection section for information on the first two stages of staged injection. Setup Notes WARNING: ONLY USE IGNITION LIMITING WHEN AUXILIARY INJECTION IS ACTIVE. This is because fuel limiting mode only cuts Auxiliary Injection channels setup for Primary or Secondary injection. · Injectors wired to Auxiliary Injection drives should have their driving mode and currents configured in the Injector Setup menu. · This function requires Fuel Injection Drives 5-8 so is not available on all Link ECUs. · All Auxiliary Injection channels are OFF when the engine speed is 0. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.