Demetris Posted January 20, 2018 Report Share Posted January 20, 2018 Have some issues with gear display. I have setup my Gear detection all gears voltage as the volt i get on each gear from anvolt5 ( its where i connect the analog potensiometer of gearbox ) My problem now is as the voltages are correct for each gear the ECU it does not display the correct gear. As you can see on the shots, i am on N and the voltages is correct ! but ECU things i am in 1 gear ! Any hits ? dont know what else to check ! And its really irritating as i have to remember all the time what gear i am on : ( Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 20, 2018 Report Share Posted January 20, 2018 This is odd, most of your settings visable look correct. When I duplicate your settings on bench it works ok for me. Are you on latest firmware 5.6.5.3389? Can you attach your tune file or send to Quote Link to comment Share on other sites More sharing options...
Demetris Posted January 20, 2018 Author Report Share Posted January 20, 2018 Yes i have the latest firmware ! Also e-mail to you the file i am testing on the car ! I know that looks stupid that why i ask for help ! bcs as i see also the settings everything looks correct ! Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 20, 2018 Report Share Posted January 20, 2018 17 minutes ago, Demetris said: Also e-mail to you the file i am testing on the car ! I have received your file and briefly tested it, it seems to work correctly for me. My only thought now is perhaps there is a corrupt table or something in the background? Lets try a factory restore: ECU controls>restore to factory settings. Choose yes for both messages that follow. Powercycle ECU (turn power off then back on). File>open, then load in your original map. Test gear detection again. Quote Link to comment Share on other sites More sharing options...
Demetris Posted January 20, 2018 Author Report Share Posted January 20, 2018 1 minute ago, Adamw said: I have received your file and briefly tested it, it seems to work correctly for me. My only thought now is perhaps there is a corrupt table or something in the background? Lets try a factory restore: ECU controls>restore to factory settings. Choose yes for both messages that follow. Powercycle ECU (turn power off then back on). File>open, then load in your original map. Test gear detection again. OK ! i will give it a try tomorrow and come back ! hope will be the solution to my problem ! thanks ! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.