Jump to content

DI not saving settings when cycling on/off


Recommended Posts

I have a weird one. 

I have a DI4 input which is a switch to ground using the internal pull up. once this is set up the switch/input works as it should no worries. When you turn the Ign off and back on again the switch DI4 is active, go back and check the settings and the pull up has been turned back to off.. Changing this and storing it does not seem to resolve the issue. 

any thoughts? 

i have DI3 set up the same way, next to it on a switch panel. configured for boost dual map modes and this works fine and has saved fine,. 



Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...