Newb: Defi Temp sensor Cal Table

[roarpw]

Hi All, 

 

very much a newb in terms of setting up and altering my Vipec setup...

 

i have a plug in type ecu on an r33 RB25det and i currently have a couple of defi temp sensors plugged into the ecu analog inputs and i am wanting to ensure the calibration table used is correct?

any help would be greatly appreciated as i seem to be having a lot of difficulty finding a calibration table to suit from Defi. 

 

Cheers,

 

[Adamw]

If you have a multimeter you could pull the sensor out, measure the resistance at about 20degC then again in boiling water.  Let us know those two points and we will see if it matches any of the common sensor calibrations.  Im assuming they are not still connected to a gauge as well?

[roarpw]

Hi Adam, Thanks for that i will give that a go, no the sensors aren't connected to the gauge any more they are installed and hooked up to the Vipec.