Jayster Posted April 7, 2018 Report Share Posted April 7, 2018 Hi, I have a GTTLink and I am attempting to setup a tablet view to be used as a dashboard, I would like to have a speedo in mph or both. However currently I am only able to get it to display the speed sensors in kph. Is there any way to have it display both or even change it to mph? Thanks Quote Link to comment Share on other sites More sharing options...
GregM Posted April 7, 2018 Report Share Posted April 7, 2018 Go into "options", select "units" and then "options" again and change speed to mph Quote Link to comment Share on other sites More sharing options...
Jayster Posted April 7, 2018 Author Report Share Posted April 7, 2018 10 hours ago, GregM said: Go into "options", select "units" and then "options" again and change speed to mph I tried that however it still only shows it in kph? Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 7, 2018 Report Share Posted April 7, 2018 The units settings have two “sets”, have you set speed to MPH in both metric and imperial sets? Quote Link to comment Share on other sites More sharing options...
Jayster Posted April 8, 2018 Author Report Share Posted April 8, 2018 4 hours ago, Adamw said: The units settings have two “sets”, have you set speed to MPH in both metric and imperial sets? No I had only set the application to imperial and checked it was set to mph in the options, I'll try changing both to mph. I assume there is no way to have it read both at once? Quote Link to comment Share on other sites More sharing options...
Jayster Posted April 14, 2018 Author Report Share Posted April 14, 2018 I have it reading mph now, I needed to use the driven/undriven wheel speed output Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 15, 2018 Report Share Posted April 15, 2018 It sounds like you might be displaying the wrong parameter. Can you attach a copy of your layout file. >Layout>Save Layout as Quote Link to comment Share on other sites More sharing options...
Jayster Posted April 16, 2018 Author Report Share Posted April 16, 2018 On 4/15/2018 at 3:33 AM, Adamw said: It sounds like you might be displaying the wrong parameter. Can you attach a copy of your layout file. >Layout>Save Layout as Sorry, my last post was not very clear, that was indeed the case. I now have it resolved thanks. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.