Ability to control two 3 or 4 ports

[llabmik2]

Would it be possible to add the ability to control either two 3 port or two 4 port boost controllers with two separate WGDC maps for compound setups? That way you can run your high pressure turbo up to like 30psi, and run the low pressure turbo at like 20psi, without using a manual boost controller on either one of them.

[Confused]

You'd not get the trimming, but my initial thoughts is that you could potentially set one output up as a GP PWM output, with a 3D table. You could use this as your low pressure WGDC table, and then use specific WGDC tables, trims etc to tweak your high pressure accordingly.

[llabmik2]

1 hour ago, Confused said:

You'd not get the trimming, but my initial thoughts is that you could potentially set one output up as a GP PWM output, with a 3D table. You could use this as your low pressure WGDC table, and then use specific WGDC tables, trims etc to tweak your high pressure accordingly.

Didn't think of that. That would work no problem though.