BlackBeautyGermany Posted October 25, 2018 Report Share Posted October 25, 2018 Hello, i think i have problems in my fuel setup. I want to use 8 high resistance injectors on 4 injector drives. The configuration is group staged. 4 injectors at the head and 4 before the individual throttle body for maximum power. Is it possible to control this at the Link without a resister pack? Quote Link to comment Share on other sites More sharing options...
BlackBeautyGermany Posted October 25, 2018 Author Report Share Posted October 25, 2018 Hello, i think i have problems in my fuel setup. I want to use 8 high resistance injectors on 4 injector drives. The configuration is group staged. 4 injectors at the head and 4 before the individual throttle body for maximum power. Is it possible to control this at the Link without a resister pack? Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 25, 2018 Report Share Posted October 25, 2018 Yes that will be fine. The injector drives are good for 5A continuous each, so you can probably have 4 or 5 common high impedance injectors per drive. Edit, I found you had posted in both G4 and G4+ sections so moved it here. Quote Link to comment Share on other sites More sharing options...
BlackBeautyGermany Posted October 25, 2018 Author Report Share Posted October 25, 2018 I think i have the wrong resistors installed. can I combinate 2 high resistance on one injection channel without a balast resistor? If i combinate 2 injectors with 14 Ohm, i have 7 Ohn at one injection channel. Is this ok for the Link Ecu? Quote Link to comment Share on other sites More sharing options...
rrob Posted October 25, 2018 Report Share Posted October 25, 2018 Connect them in parallel. Quote Link to comment Share on other sites More sharing options...
BlackBeautyGermany Posted October 25, 2018 Author Report Share Posted October 25, 2018 yes i want to connect them parallel. So the resistance is going down to 7 Ohm, if i connect 2 14 ohm injectors parallel. If i connect them in row, i have 28 Ohm resistance. Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 25, 2018 Report Share Posted October 25, 2018 As I said in my reply above, it is fine to connect two injectors in parallel direct to drive. 7ohm load is only going to need 2A, the drives can supply 5A. You do not need any resistors. Quote Link to comment Share on other sites More sharing options...
BlackBeautyGermany Posted October 25, 2018 Author Report Share Posted October 25, 2018 ok thanks a lot Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.