EvilEvolution8 Posted December 28, 2018 Report Share Posted December 28, 2018 Hello Guys, i have some questions about sensor ground and shield. 1 - I have CRANK, CAM, KNOCK with shield...can I join the three shield and connect these to pin A7 (Shield/Gnd) of Thunder ? 2- One sensor ground cable and one shield cable : can I join both and connect these to pin A7 (Shield/Gnd) of Thunder ? Thanks guys Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 28, 2018 Report Share Posted December 28, 2018 Yes to both. In our Link looms the trigger grounds and shields are connected to A7, the knock sensor grounds and shields are connected to B7. But they can all be spliced to the one pin if that works better for you. Quote Link to comment Share on other sites More sharing options...
EvilEvolution8 Posted December 28, 2018 Author Report Share Posted December 28, 2018 Thanks Adam, I think you intend B17 not B7. So...shield and Ground sensor can be connected to pin Gnd/Shield...right? I have the same situation in my harness : - crank and cam ground and shield to A7 - knock ground and shield to B17 Is ok right? Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 28, 2018 Report Share Posted December 28, 2018 7 minutes ago, EvilEvolution8 said: I think you intend B17 not B7. Yes, probably. Replying from my phone while eating breakfast so going from memory. It is the pin next to or below the 2 knock pins labeled shield/gnd. Quote Link to comment Share on other sites More sharing options...
EvilEvolution8 Posted December 28, 2018 Author Report Share Posted December 28, 2018 Yes...Is B17...perfect...Is my same config. Enjoy your breakfast. Thanks Adam Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.