Engine does not start after installing base map

[namre]

Hello gurus,

After we have installed the link base maps of sti v10 engine did not start.

Attached are two logs from pclink.

Can you please help on what causes this?

Thanks in advance.

notstarting.llg

notstarting2.llg

[jonnyt80]

stick up your map for reference.

also a bit more info on the car would also help

[Adamw]

I'm overseas on holiday so have only had a brief look, but the first thing I see is the MAP is reading wrong.  As per the manual you need to make sure all inputs are set up, calibrated and reading correctly before starting .  It should read near 100kpa with the engine off, yours is reading 25kpa.

[namre]

On 1/3/2019 at 12:16 AM, Adamw said:

I'm overseas on holiday so have only had a brief look, but the first thing I see is the MAP is reading wrong.  As per the manual you need to make sure all inputs are set up, calibrated and reading correctly before starting .  It should read near 100kpa with the engine off, yours is reading 25kpa.

Thanks. Calibration was the issue.